Error updating locale cisco 7911
The Headset, Mute, and Speaker buttons begin to flash in sequence.4.) Press 123456789*0# within 60 seconds after the Headset, Mute, and Speaker buttons begin to flash.5.) If you enter this key sequence correctly, the phone displays this prompt: Keep network cfg? I'm using Switchvox Free 1.0 version, but it's WUI only so how do you load the SEP files?I've turned off natting and I'll test it again when I get back to the office, but I don't have high hopes.P003-07-5-00; Secure universal application loader for upgrades from images 5.x or later.2.) Copy the following config files in the tftp dir ; Common config options relating to all SIP phonesxml Default. XML ; Allow the phone to boot and load the SIP firmware from the server xml Due to inconsistent coding by Cisco, different firmware may look for different case-sensitive versions of the same xml file, thus the need for at least the two variations above to cover new phones and a good portion of older one's.; Used to control specific phone behavior ; Where XXXXYYYYZZZZ is the MAC address of the phone.
I would have attached samples to the forum but it's not accepting my file.After going through the manual via Cisco's website I entered all the correct settings on the phone and it reached the PBX and now works well.I say "well" because incoming calls are intermittent, sometimes calls inbound to my extension do not connect but timeout and go to voicemail. but all of my setting parameters are under Settings Could any one give me some help on this ???The phone begins its power up cycle.2.) Running Skinny firmware press and hold # while the phone boots.The phone will indicate the reset sequence has been detected.3.) Release the # key.